HQP-100 concrete slicer operating procedures - Database & Sql Blog Articles

HQP-100

Concrete slicer

Operating procedure

1

Turn on the power and water.

2

Select the appropriate fixture according to the diameter of the core sample, clamp the core sample and turn it to the center of the chassis to tighten the clamp.

3

Loosen the upper and lower tensioning handwheels and turn the lifting handwheel. When the end face of the grinding wheel is away from the core end face

1mm

Stop when. Then tighten the upper cable grip handle, open the water inlet valve to open the water, close the power switch, turn the grinding wheel, then turn the hand wheel counterclockwise, and turn the micro handwheel clockwise to lower the grinding head. When the end face of the grinding wheel contacts the end face of the sample, the grinding head is ground until the end face of the sample is flattened.

4

After the grinding is completed, turn off the power supply and the faucet valve and turn the micro-handwheel counterclockwise to make it in the upper limit position.

5

Loosen the clamp tensioning handle, remove the clamp together with the sample and install it in reverse, repeat

2

,

3

,

4

The step action grinds the other end face. Until the end of the core sample meets the requirements.

6

After the microtome is used, turn off the power and wipe the machine clean.